Servo Motor Encoder Controlled Free-Debugging & Maintenance 5 Million Times Swing Gate SJSDZB10

Catalogue for Swing SJSDZB10 & flap gate SJSDZY-14.pdf

Brief Introduction

Compared with traditional swing gate, SJSDZB10 adopts all-new permanent magnet
synchronous servo motor and encoder control system, by which the device is
suitable with voltage ranges from AC175--300W, and the life cycle is prolonged
up to 5 million times; Sensor or mechanical position is not necessary any more, the
structure is more simply, thus maintenance cost is cut down too much. As all operations
are controlled by the encoder program, maintenance is much easier and mechanic failures
are reduced largely. As motor keeps homothermal all the time, it is able to work extreme
environment.

Features

1. Reliable, low noise, smooth operation and long life cycle
2. Configurable opening speed to meet different requirements
3. With failure self-diagnosis and alarm prompt function, convenient to us and
maintenance.
4. Multi-operation models optional
5. PLC positions door location accurately, no sensor and mechanic position needed
6. Automatic reset: In stipulated time, if no body passes after door opens, the flap gate
will close automatically.
7. Anti-tail:many persons pass through the gate at one time is not acceptable
8. Sunscreen, cold-resistant, heat-resistant, water-proof design, suitable for indoor
9. Autolock function: no mechanical auto lock needed, by which improve reliability and life
cycle. No mechanical noise
10. PLC swing position signal output positions the swing location real time and give out
alarm signal
11. Servo driving control: wide regulating range, high position accuracy, fast speed, smooth
operation, low noise, high torque at low speed, strong overload, high reliability
12. Anti-pinch: In the process of reset, the motor stop working in stipulated time if the
arm is blocked. Reset again after default delay time and the force is <=2kg
13. Easy to program operation mode by built-in little keypad on master controller
14. Easy to set NO/NC to meet different requirements
15. Open automatically when power off and close when power on


Parameters